Opens in a new tab

Organic MK II Power Cord

Power with redesigned grounding architecture and a continuous copper path

The Organic MK II power cord features enhanced grounding geometry with 99.999% OFC copper throughout, cryogenically treated connectors, and DAD (Damped Air Dielectric) construction that maintains conductor isolation while eliminating the typical brass contact resistance found in standard terminations.

Available connectors:
Spade
Available colors:
Black
Available lengths:
1.0m, 1.5m, 2.0m, 2.5m, 3.0m, +.5m custom cable increments
Available colors:
Spade
Available connectors:
Black
Available lengths:
1.0m, 1.5m, 2.0m, 2.5m, 3.0m, +.5m custom cable increments

Construction

  • Direct copper-to-copper interfaces without solder on XLR and RCA positive connections
  • Cryogenic treatment of all connector components
  • Geometry optimized for low capacitance throughout
  • Further reduced dielectric mass for minimal conductor interaction
  • Custom-designed connectors specifically engineered for each cable type
  • Argento-level fit and finish standards

Materials

  • 99.999% pure OFC annealed copper ribbon conductors throughout
  • Custom connectors with contacts made from the same 99.999% OFC copper—no brass or copper alloys
  • Teflon (PTFE) dielectric in all connectors for lowest dielectric constant
  • DAD (Damped Air Dielectric)—low-mass fibers with minimal conductor contact
  • Machined Delrin/POM polymer connector housings with laser engraving
  • Zero shielding for minimum capacitance
Read more about VDM

Have questions about the Organic MK II Power Cord?

Contact Us

Experience the Organic MK II Power Cord and other Argento products in person.

Find a Dealer

Related Organic Products

  • Argento’s conductors are made from 99.9999% (“six-nines”) pure silver, which contains no more than about one part per million of other elements. Silver has the highest electrical conductivity of any metal, about 5–7% higher than copper. At the microscopic level, drawn metal is made of many small crystals, or grains, and impurities and oxides tend to gather at the boundaries between them. Argento uses a slow, controlled casting process, similar to Ohno Continuous Casting (OCC), to make silver with greatly elongated grains. A signal therefore crosses far fewer grain boundaries over the length of the cable. Combining high purity with this extended crystal structure is meant to keep the conductor as uniform as possible, so the cable passes the audio signal with as little change as possible.
    A speaker cable carrying a signal is subject to mechanical vibration. Some comes from the magnetic forces between conductors carrying current, and some comes from the speakers, floor and room. Conventional cables surround their conductors with solid polymer insulation such as PVC, polyethylene or PTFE. Air-dielectric designs instead hold the conductors loosely in tubes or spacers. Both approaches can let the conductors and insulation resonate at their natural frequencies. Argento’s VDM is a proprietary damping compound applied around the conductors to absorb this energy and dissipate it as heat. The goal is to reduce microphonic effects, where physical vibration turns into small amounts of electrical noise, which Argento associates with coloration and harshness in the high frequencies.